Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[thejoewin]

i was able to bridge my 4500, but only 1 device was able to connect. it was probably the canopy had pppoe connection. it doesn't have dhcp setup. it's funny how i was able to connect to the canopy page, without direct line to it.

yup used internet explorer and view menu and no style.

Subscriber Module Stats
 
Session Status :REGISTERED VC 59 Rate 2X/1X
PPPoE Session Status :In Session
Registered AP :0a-00-3e-25-f4-be
Power Level :Actual: -62 dBm Min: -62 dBm Max: -60 dBm
Jitter (Interference Level) :Actual: 3 Min: 1 Max: 15
Air Delay :42 approximately 0.39 miles (2058 feet)

is this the router mac address?0a-00-3e-25-f4-be
should i put that in the manual configure setup in dlink router

[FurryNutz]

Seems like if your wanting to turn the 4500 into and AP, this is the best option to use:
Turning a router into an AP.

[thejoewin]

ok, i got public ip now. i can host, but i'm lagging so i should turn on GF right?

[FurryNutz]

Yes, lets try GF ON now...

How did you get Public IP address ?

[thejoewin]

i had a tech from local looked at it. he went into the canopy and changed some settings. my router is now connected using PPPoE connection. i'm going to try GF later and see if the lag disappears.

[FurryNutz]

Ok should only need to turn it back on. Just use the same rules I helped you put in. Hope it works.

 

[thejoewin]

my mtu is set to 1492 should i set it to 1500, the voice is cutting on and off. or his network is high traffic.

[FurryNutz]

Ask ur isp what mtu should be.

[thejoewin]

nevermind, i am such a noob sometimes, PPPoE can't be set to 1500.