• February 23, 2025, 03:09:51 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: D-ViewCam 3.2 doesn't work with more than two cameras monitored  (Read 8066 times)

stevem38

  • Level 1 Member
  • *
  • Posts: 3
D-ViewCam 3.2 doesn't work with more than two cameras monitored
« on: July 10, 2012, 05:59:32 PM »
I have (2) 942-L, and (1) 5222-L on one network.  port forwarding set on router; (942) 192.168.1.3:1024, (942) 192.168.1.4:1025, and (5222) 192.168.1.8:80.  no matter if all 3 are connected to dViewCam, only two will work at a time.  Disconnect any third, and they work fine.  reconnect 3rd, and one disconnects intermittently.  On a side note, if I run a different program on another computer (iMac); i.e. IP Camera Viewer, they all work fine.  I know, I know, but I like DViewCam, because it's the only thing running the PC computer.  Any help would greatly be appreciated.  I'm not to tech savy.

Thank you,
Steve
Logged

Mackerel

  • Level 3 Member
  • ***
  • Posts: 348
Re: D-ViewCam 3.2 doesn't work with more than two cameras monitored
« Reply #1 on: July 25, 2012, 11:00:40 AM »
Must be in the special setup, port forwarding, etc, as I am using 3.2 with a large number of cameras (920's mostly) straghtforward, and I have no problem monitoring more than 2. Bandwidth is an issue with 10+, but I am using wired connections so as not to influence WiFi bandwidth...
Logged

stevem38

  • Level 1 Member
  • *
  • Posts: 3
Re: D-ViewCam 3.2 doesn't work with more than two cameras monitored
« Reply #2 on: July 25, 2012, 04:06:02 PM »
I wish I could figure it out.  I even took two off wifi for the same concerns with bandwidth and hard wired them into the router with no difference.  baffling....
Logged

stevem38

  • Level 1 Member
  • *
  • Posts: 3
Re: D-ViewCam 3.2 doesn't work with more than two cameras monitored
« Reply #3 on: July 28, 2012, 04:03:44 PM »
I think I finally figured it out, sort of.  Did away with QoS parameters I set.  Perhaps they were wrong.  Then restarted the PC (had some kind of Ip conflict, not sure why since I set to static.  Though they disconnect every now and then, they do reconnect, and ALL three are up and running.

Thanks for all the helpful info and great suggestions............
Logged