• November 02, 2024, 04:29:37 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Cannot Remote Administer Via WAN  (Read 2708 times)

hulbertech

  • Level 1 Member
  • *
  • Posts: 1
Cannot Remote Administer Via WAN
« on: November 28, 2012, 10:28:47 AM »

I've seen a few other posts on this subject with no resolution that I could find, so I figure I would ask about it again.
My Dlink DIR-655 is setup to allow remote administration through the WAN IP port 8080 - I can ping the outside IP address from offsite, but I can not connect a browser.
What is the resolution to this?
Thanks in advance..
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Cannot Remote Administer Via WAN
« Reply #1 on: November 28, 2012, 10:31:02 AM »

Link>Welcome!
What Hardware version is your router? Look at sticker under router.
Link>What Firmware version is currently loaded? Found on routers web page under status.
What region are you located?

What ISP Service do you have? Cable or DSL?
What ISP Modem do you have? Stand Alone or built in router?
What ISP Modem make and model do you have?

When trying to connect from a remote out side WAN site, use the following:
http://##.###.###.###:8080
The IP address needs to be a public IP address the router gets from the ISP modem.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.