Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[jkreijger]

Hi,
I connected my camera to my router with a network cable. It is a DCS-2121, H/W Ver A2, with firmware 1.04_FR.
It received an IP address and I could access it fine with a web browser.
Then I configured it to work wirelessly.
I disconnected the cable but the camera wasn't accessible.
Since I couldn't find it I re-attached it with a network cable, but this didn't work.
So I pressed the Reset button to start over again.
However, now I cannot get it to work anymore.
When I plug in the camera and have it connected with a network cable to the router the status light remains RED.
When I plug it in without a network cable the status led remains RED.
When I connect it with a network cable to a computer directly, the status led remains RED.
I've tried changing the network settings of my router to use 192.168.0.x as range, but it makes no difference. In all cases the status indicator remains RED.
Any suggestion of what else I can try?
Thanks,
Jeroen.

[i8u]

Hi

Any solution on this?
I have the exact same problem

regards
i8u

[WyreNut]

Jumping in a bit late here, but are you sure you're doing the Factory Reset correctly?  On my Dlink camera (DCS5300G), I have to hold the reset button depressed for two cycles, then release.

Check your user guide.

WyreNut

[davidcam1983]

alguna solucion para esto por favor si pudieran regalar el firware original 1.4 o como instalarlo seria de gran ayufda

[JavaLawyer]

You can find the DCS-2121 firmware here: tsd.dlink.com.tw