Topic: NAS LOCKED RED LIGHTS (Read 3829 times)

miracomovoy · « **on:** September 17, 2016, 12:45:16 AM »

Hello, need help please.
I updated my DLink NAS-320LW and restart the computer can not connect with in any way.
Within the router does not appear, and I get red lights on the site are the hard disk. Is there any way to make a hardreset. I can load the old firmware in any way possible?
Thanks ... (sorry for my English I'm using Google translation)

ivan · « **Reply #1 on:** September 17, 2016, 02:42:05 AM »

The reset button is on the bottom of the unit below the left bottom corner of the label. Use something small enough to fit through the hole and press the button in for about 10 seconds. This should restore factory defaults if the new firmware was flashed correctly.

If that does not work you will have to learn about soldering and using a USB/SERIAL 3.3v adapter and uboot.

FurryNutz · « **Reply #2 on:** September 22, 2016, 06:47:21 AM »

Any status on this?

Quote from: miracomovoy on September 17, 2016, 12:45:16 AM

Hello, need help please.
I updated my DLink NAS-320LW and restart the computer can not connect with in any way.
Within the router does not appear, and I get red lights on the site are the hard disk. Is there any way to make a hardreset. I can load the old firmware in any way possible?
Thanks ... (sorry for my English I'm using Google translation)

D-Link Forums

News:

Author Topic: NAS LOCKED RED LIGHTS (Read 3829 times)

miracomovoy

NAS LOCKED RED LIGHTS

ivan

Re: NAS LOCKED RED LIGHTS

FurryNutz

Re: NAS LOCKED RED LIGHTS