Hi there,
is there anybody here who has managed to set up an AP array with DAP-2360 devices?
I'm running two devices in my house (hardware version A1, firmware 1.11 12:39:06 11/15/2013). Both are now running with the same SSID, which works fine but configured individually.
In order to synch settings, I set up an array, where one is defined as master and the other one is defined as slave. The idea is to configure only the master, so that all settings are then synced with the slave.
Unfortunately, I could not manage to set up the array. What happened up to now?
- For both devices, I enabled the array, defined a common name and password for it, where the admin password for each single device remained the same and different.
- Saved configuration and restarted both deivces
- When I perform a scan on the master device, I do not receive a result. The device stays disconnected
- When I perform a scan on the slave device, the array is found and can be checked. I select the attributes to be synched and click the save button. But the device stays disconnected.
What do I need to do in order to add the slave device to the array?
I heard about an additional software "array manager". Is it required to use this feature? I tried but failed since the software is not running on Windows 10.
Kind Regards,
Dirk
