Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[lulzintosh]

Hello,
I just got a DIR-615 (T1).

So this is how my connection works.


Modem -> Router 1 (Linksys E1200) -> Router 2 (D-Link DIR-615 T1).

Linksys E1200:
IP Address / Default Gateway: 10.0.0.1
IP range of clients: 10.0.0.100 - 10.0.0.200

D-Link DIR-615 T1 (Static connection to Router 1):
IP Address: 10.0.0.68
Default Gateway: 10.0.1.1
IP range of clients: 10.0.1.100 - 10.0.1.200


Now, prior to the D-Link DIR-615 T1 I had another Linksys router, the WRT54G, which is about 8 years old.
With the previous setup, when my machine was connected to router 2, I was able to access router 1 by entering 10.0.0.1 in the browser.

Now with the D-Link DIR-615 (T1) I am unable to do the same. The connection just times out.

Any suggestions?

[FurryNutz]

Link>Welcome!

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware version is currently loaded? Found on the routers web page under status.
• What region are you located?

I presume your trying to access the 615s UI, if so, try 10.0.1.1 or the 615s router IP address.

[lulzintosh]

Link>Welcome!

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware version is currently loaded? Found on the routers web page under status.
• What region are you located?

I presume your trying to access the 615s UI, if so, try 10.0.1.1 or the 615s router IP address.

Hardware version: T1
Firmware version: 20.07 (the latest)
India

Incorrect, I am trying to access the E1200's UI but I am unable to.
I could when I was using the Linksys router with the same settings, but not with the D-Link router.

[FurryNutz]

The other router needs to be on similar same sub net at the 615, i.e. 192.168.12.1, or put the other router into LAN to LAN AP mode and give it a static IP address that the 615 uses, i.e. 192.168.0.12 and use that IP address to access that routers web page.