• February 23, 2025, 03:35:53 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: accessing the admin page after initial setup  (Read 4003 times)

compozed

  • Level 1 Member
  • *
  • Posts: 1
accessing the admin page after initial setup
« on: January 23, 2010, 07:28:39 PM »
I can't seem to http to the 1522's administration/setup page after initially having it connected to my pc for 1st time setup. It now sits in another room, used in bridge mode....it has good connectivity, I have a dish network DVR and WDTV media player connected to it, and both have internet connectivity, so I know it's communicating wirelessly with my two-wire router/modem, but since then, I haven't been able to http to the 1522's IP address, which I left at 192.168.0.50...My pc (which is connected to the gateway modem/router) has it's IP address set to 192.168.0.53 and  my gateway modem/router  is set to 192.168.0.57. I basically changed the router/modem and this pc's addresses to match the default for the 1522 bridge, so I know everything is on the same subnet OK. Any ideas? Is it even possible to access the admin/setup page of the 1522 wirelessly, or does it require having a pc directly connected?
Logged

gniknalu

  • Level 1 Member
  • *
  • Posts: 14
Re: accessing the admin page after initial setup
« Reply #1 on: April 05, 2010, 02:25:13 PM »
Don't use it's IP address, use it's name. Use http://dlinkap
Logged