• February 23, 2025, 03:18:31 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: swap HD_b2 and HD_a2?  (Read 3325 times)

bklynkid

  • Level 1 Member
  • *
  • Posts: 12
swap HD_b2 and HD_a2?
« on: May 15, 2009, 01:13:02 PM »
I recently put a 2nd hard drive into my DNS-321, and knowing better than to leave my old HD in it while I format the new one I took out out. (last time I did that my existing HD was formatted as well - thanks a lot!) Doing so and formatting the new drive, my new drive now became HD_a2 while my old drive, once re-inserted, became HD_b2. How can I swap these around again so that my old drive is once again HD_a2 (so I can run a funplug from it).

I tried physically swapping both drives, didn't work. I tried removing both drives, booting up, then reinserting just the drive I wanted to become HD_a2. This didnt work either.

How can this be done? ???
« Last Edit: May 15, 2009, 01:30:14 PM by bklynkid »
Logged

ECF

  • Administrator
  • Level 11 Member
  • *
  • Posts: 2692
Re: swap HD_b2 and HD_a2?
« Reply #1 on: May 28, 2009, 09:00:26 AM »
What firmware are you running? And what is HD_a2 and HD_b2? The DNS-321 labels the drives as Volume_1 and Volume_2.

Please provide steps to reproduce issue? the bays used ect...
Logged
Never forget that only dead fish swim with the stream