Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[mthroesch]

Here is the setup i want to use.
DGL-4500 (Master) has wireless and wired
     |
     |--DIR-655 (Slave) has wireless and wired
     |--DIR-655 (Slave) Has wireless and wired

I have a 3 floors to setup. and need all computers to see each other is this possible.

[FurryNutz]

This is probable I believe if you connect each of the 655 routers via LAN ports only to the LAN ports on the 4500. WAN ports in this configuration will not be used. I would recommend assigning static IP addresses to each of the 655 routers. Setting up WiFi will probably be different since officially you can't bridge these routers. This configuration will introduce a more complex setup. However if you look in this forum, you will find information on accessing hidden options that allow for bridging for WiFI which would be preferred.

Another option would be to connect a LAN switch to the 4500 and wireless APs that are able to join a main 4500 WiFi AP and provide extended signals and range. Wire up the floors for those devices that need wire. WiFi the rest.
Turning a router into an AP.

[usmarine0622]

no make this work follow the steps below on your slave routers.

If you are connecting the D-Link router to another router to use as a wireless access point and/or switch, you will have to do the following before connecting the router to your network:
• Disable UPnP™
• Disable DHCP
• Change the LAN IP address to an available address on your network. The LAN ports on the router cannot accept a DHCP address from your other router.
To connect to another router, please follow the steps below:
1. Plug the power into the router. Connect one of your computers to the router (LAN port) using an Ethernet cable. Make sure your IP address on the computer is 192.168.0.xxx (where xxx is between 2 and 254). Please see the Networking Basics section for more information. If you need to change the settings, write down your existing settings before making any changes. In most cases, your computer should be set to receive an IP address automatically in which case you will not have to do anything to your computer.
2. Open a web browser and enter http://192.168.0.1 and press Enter. When the login window appears, set the user name to Admin and leave the password box empty. Click Log In to continue.
3. Click on Advanced and then click Advanced Network. Uncheck the Enable UPnP checkbox. Click Save Settings to continue.
4. Click Setup and then click Network Settings. Uncheck the Enable DHCP Server checkbox. Click Save Settings to continue.
5. Under Router Settings, enter an available IP address and the subnet mask of your network. Click Save Settings to save your settings. Use this new IP address to access the configuration utility of the router in the future. Close the browser and change your computer’s IP settings back to the original values as in Step 1.
6. Disconnect the Ethernet cable from the router and reconnect your computer to your network.
7. Connect an Ethernet cable in one of the LAN ports of the router and connect it to your other router. Do not plug anything into the Internet (WAN) port of the D-Link router.
8. You may now use the other 3 LAN ports to connect other Ethernet devices and computers. To configure your wireless network, open a web browser and enter the IP address you assigned to the router. Refer to the Configuration and Wireless Security sections for more information on setting up your wireless network.