• February 22, 2025, 11:04:26 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Red Light  (Read 5114 times)

danymora131

  • Level 1 Member
  • *
  • Posts: 9
Red Light
« on: August 05, 2013, 06:18:55 PM »
I put my DIR-505 on hotspot mode and I accidentally disconnected it. Now I only get a red light and can't reset or do anything with it. I left it connected over night but I still get the red light. After updating the firmware to the latest it ran smoothly but now it will not work. I can't connect to it even with ethernet.
Logged

holmes4

  • Level 3 Member
  • ***
  • Posts: 123
Re: Red Light
« Reply #1 on: August 08, 2013, 07:54:58 AM »
Did you do the reset by pushing a paperclip into the hole between the two jacks - hold it in until the LED flashes.
Logged

danymora131

  • Level 1 Member
  • *
  • Posts: 9
Re: Red Light
« Reply #2 on: August 08, 2013, 05:47:06 PM »
I held it for over a minute and it still didn't flash. I disconnected and reconnected it to the power and tried again and it didn't do anything
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Red Light
« Reply #3 on: August 08, 2013, 06:19:38 PM »
You may need to phone contact your regional D-Link support office and get some additional help..Even RMA.

Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.