• November 01, 2024, 07:31:42 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: D-link DSL-2740R Problem  (Read 4014 times)

Blackchest

  • Level 1 Member
  • *
  • Posts: 1
D-link DSL-2740R Problem
« on: August 11, 2013, 08:01:38 AM »

Hi to all.

I have a problem with the wifi on my router.
It suddenly stopped to be seen by any device in my house.
The wifi signal is green, and in the settings it says that it's on, but i cannot see the signal either with pc or smarthphones..

Any guess about this problem?

Thanks all!
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: D-link DSL-2740R Problem
« Reply #1 on: August 12, 2013, 11:40:52 AM »

Link>Welcome!
  • What Hardware version is your modem? Look at sticker under modem.
  • Link>What Firmware version is currently loaded? Found on the modems web page under status.
  • What region are you located?


Wireless Configurations
Links>Wireless Installation Considerations and Managing Signal Congestion
  • Ensure the default (dlink) SSID name is changed. Can be anything and not something thats already in use by any neighboring WiFi routers.
  • What wireless modes are you using?
  • 2.4Ghz Routers only: Try single mode G or N or mixed G and N?
  • Channel Width set for Auto 20/40Mhz or try 20Mhz only.
  • Try setting a manual Channel to a open or unused channel. 1, 6 or 11. 11 for single mode N if the channel is clear.
  • What security mode are you using? Preferred security is WPA-Personal. WPA2/AES Only. Some WiFi adapters don't support AES, so you might want to try TPIK only or Auto TPIK and AES.
  • What wireless devices do you have connected?
  • Any cordless house phones?
  • Any other WiFi routers in the area? Link> Use InSSIDer to find out. How many?
  • If you have any of these options, Try turning OFF or ON Short GI, WLAN Partition, HT 20/40 Co-exhistance and Extra Wireless Protection if you have it. Recommended settings are default.
  • Enable WMM Enable Under Advanced/Advanced Wireless.
  • Try setting Medium or Low power output settings and test again Under Advanced/Advanced Wireless.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.