Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[ericsimard81]

Hi, i have a d-link dir-826l a1 firmware version 1.04
I have one ipad and one western digital hard drive connect to my router.
When is no activity the power Led turn solid orange and the wifi stop but he never restart.
If i want to restart my wifi i restart manually my router with the power buttom behind.
What can i do for stopping the energy saver ?
Thanks for your help.
Eric

[FurryNutz]

Link>

Welcome!

• What region are you located?
• Are you wired or wireless connected to the router?
• Has a Factory Reset been performed?
• Was a Factory Reset performed before and after any firmware updates then set up from scratch?
• Was the router working before any firmware updates?

Internet Service Provider and Modem Configurations

• What ISP Service do you have? Cable or DSL?
• What ISP Modem Mfr. and model # do you have?
• What ISP Modem service link speeds UP and Down do you have?
• If this modem has a built in router, it's best to bridge the modem. Having 2 routers on the same line can cause connection problems: Link>Double NAT and How NAT Works. To tell if the modem is bridged or not, look at the routers web page, Status/Device Info/Wan Section, if there is a 192.168.0.# address in the WAN IP address field, then the modem is not bridged. If the modem can't be bridged then see if the modem has a DMZ option and input the IP address the router gets from the modem and put that into the modems DMZ.
• Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values
• For DSL/PPPoE connections on the router, ensure that "Always ON" option is enabled.

• Check cable between Modem and Router, swap out to be sure. Link> Cat6 is recommended.

Routers do not have any energy saver features. There always ON or OFF if switched OFF.
 

[ericsimard81]

Hi, im from Québec Canada
I hâve one ipad wireless and one western digital ethernet hard drive in port 1 on the dlink router
I bought m'y router in july. The problems start last weekend. Before the router works perfectly on the firmware 1.00 (not updated)
I made à factory reset with the buttom under the router.
The factory reset was make before i made the update for the firmware 1.04. I make the update with à ethernet câble (ont wireless) with my portable computer. My portable computer is mostly closes because i use my ipad.
I dont installer firmware 1.01, 1.02 1.03. I only install the 1.04.
I hâve on modem câble ethernet. They hâve nô router in my modem. The câble are ok and is new.
The router work perfectly Wehn Twitter Led are. Green but hé stop the wifi Wehn is nô activity and hé dosent restart.

Tanks for your help.
Sorry for mistake im french

[FurryNutz]

I recommend that you phone contact your regional D-Link support office and have them help you with the setup of this router with your ISP modem.