Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[asamalikum]

Hi, i just bought a new NAS (Dlink 323). After hardware set up, i'm suppose to configure the system by accessing the configuration on WEB UI. Therefore i figure out the NAS ip address from the DHCP client list on my router settings. Hence i type in http://192.168.1.35/ (1.35 being the address of NAS) and it keeps on loading and loading, yet nothing comes out. I'm not sure how should i set this up. Please help.

[ECF]

Try using a ping utility in Mac and try to ping the IP address of the DNS-323. Sorry I don't know were this utility is located off hand I don't use Mac all that much.

[thebeck]

On your mac, open up the Terminal app (this gives you command line access).  Then ping the NAS:

ping 192.168.1.35

If you get replies, then it is on the network.  If not, then you either have the wrong IP address or something else is wrong.  Good luck.

[asamalikum]

thank you. it does reply on the 192.168.1.35, what do i do next?

[ECF]

Try powering the unit down and back on. If that fails try resetting the unit to factory defaults using the reset button on the back. Press and hold for about 5 seconds. You may need a paper clip to press it in.

[bripab007]

I already answered your post on the other forum, but, in a nutshell, you either have a networking or browser problem.  Shouldn't have anything to do with it being a Mac.