Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Ekerstan]

I have a DIR-655, B1 with 2.11NA firmware.  My ISP connection is via wireless antenna radio on my roof pointed line of sight to the ISP relay tower.  From the rooftop antenna I have a CAT5 running down to a POE power injector with a LAN port.  If I cable connect my computer directly to the LAN port on the POE I get 11Mbps/3Mbps (exactly what I'm serviced for)...when I connect the 655 and cable connect to the LAN ports on the 655 I get 2-3Mbps/3Mbps.  Connecting wirelessly I get 6Mbps/2-3Mbps.

The other strange thing is I've connected ONLY a Netgear FS105 switch to the POE and I also then get 2-3Mbps/3Mbps.

I'll take any suggestions.  Thank you!

[Ekerstan]

Additional:

Enable Traffic Shaping - off
QoS - off
Enable Access Control - unchecked
UDP Endpoint Filtering - endpoint independent
TCP Endpoint Filtering - endpoint independent
Enable SPI - unchecked
Enable WISH - unchecked
WI-FI PROTECTED SETUP enabled - unchecked
WAN Port Speed - Auto

[FurryNutz]

Link>Welcome!

• What Hardware version is your router? Look at sticker under the router case.
• Link>What Firmware version is currently loaded? Found on the routers web page under status.
• What region are you located?
• Are you wired or wireless connected to the router?
• Has a Factory Reset been performed?

Try setting a manual WAN port speed to 100Mb or try 10Mb.

Is this a new ISP setup or has this been working ever?
Disable any IPv6 settings on the router and PC.
Does the ISP modem/injecter have a router built in?

Test router at a different location with different ISP and modem if possible.

[Ekerstan]

Thank you for your input!  I changed two settings and one or both solved the problem;

Enable IPv6 Multicast Streams - I unchecked it
WAN Port Speed - I set to 100Mbps

I think I'm good to go.  Thanks again!!

[FurryNutz]

Glad its working now, Enjoy.