• February 23, 2025, 12:20:41 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: new 825 upgaded to 2.02, network works but can't login as admin  (Read 4721 times)

Harborseal

  • Level 1 Member
  • *
  • Posts: 3
new 825 upgaded to 2.02, network works but can't login as admin
« on: July 20, 2009, 03:01:28 PM »
I got a DIR-825 B1, saved a configuration, upgraded to 2.02NA.  The firmware upgrade page counted down from 180 to 87 where it froze.  ie froze as well.  I let it run overnight then rebooted everything from my computer to the cable modem.  The network runs fine, including internet.  The loginpage saysit's running 2.02NA.  I tried admin with no password and admin with the old password I put in and neither one works.  Is there a new password to login with 2.02NA?  Thanks.
Logged

TTexas

  • Level 1 Member
  • *
  • Posts: 1
Re: new 825 upgaded to 2.02, network works but can't login as admin
« Reply #1 on: July 20, 2009, 06:41:43 PM »
It should revert to UID:  admin with the PW:  "blank"

Worst case, reset the router via the physical reset button on the back (paperclip depress for 10 seconds) and allow it to reboot and try the above uid/pw again.

Good luck,

TTx
Logged

Harborseal

  • Level 1 Member
  • *
  • Posts: 3
Re: new 825 upgaded to 2.02, network works but can't login as admin
« Reply #2 on: July 21, 2009, 09:26:46 AM »
Well, it went from bad to worse.  All lights out except for dlink blinking blue and power blinking orange.  Spent an hour with TS, no resurrection.  It gets exchanged today.
Logged

claykin

  • Level 3 Member
  • ***
  • Posts: 112
Re: new 825 upgaded to 2.02, network works but can't login as admin
« Reply #3 on: July 22, 2009, 06:09:31 PM »
Did the exchange resolve your issue?
Logged

Harborseal

  • Level 1 Member
  • *
  • Posts: 3
Re: new 825 upgaded to 2.02, network works but can't login as admin
« Reply #4 on: July 22, 2009, 10:53:38 PM »
By exchange I meant return the bad model and get a new one.  The new one is working fine (knock on wood!)  I followed the directions to get 300 mb/s - where can I read the speed from?
Logged