Hi there
I have a DGS-1210-24, H/W:A1 switch with newest firmware (v2.01.002).
With this switch I am trying to use two ports in LACP trunk mode with a Windows Server 2019.
I have tried every possible combinations, but I kepp getting failed connections.
On the switch I enable Port trunking and add ID:1 with LACP (actice/active) on two ports (eg. port 3 and 4)
On the windows server I set up NIC teaming LACP, Dynamic, Active/Active.
I do not use VLAN - all VLANS are set to standard VLAN:1 untagged.
What am I doing wrong
?
On a second switch DGS-1100-24P H/W:B2 newest firmware it works fine.
I have managed to setup LACP between the two switched using the same LACP settings as above.
Anyone have a guide on LACP for Dlink
??
