• February 23, 2025, 05:35:24 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: blinking front LED of a DNS-321?  (Read 6134 times)

bozolinks

  • Level 1 Member
  • *
  • Posts: 4
blinking front LED of a DNS-321?
« on: February 24, 2012, 09:33:29 AM »
hi guys, a couple of days now has passed. last thing I did in the DNS321 was give it a restart from the web interface. then I noticed of the blinking (flashing) front LED. hard-drives are fine I just access them both directly to my PC through SATA cables (had a RAID1 config).

should I trash it? is there anything I could do? :'(

thanks in advance for the any advice/support... :)
Logged

scottybm

  • Level 1 Member
  • *
  • Posts: 3
Re: blinking front LED of a DNS-321?
« Reply #1 on: February 26, 2012, 10:57:12 PM »
I noticed that when i put in a bad hard drive the center light would keep flashing. Don't know if this helps or not. I just pulled the drive and replaced with the working one and it stopped.
Logged

bozolinks

  • Level 1 Member
  • *
  • Posts: 4
Re: blinking front LED of a DNS-321?
« Reply #2 on: March 04, 2012, 05:28:14 AM »
thank! will try that
Logged

bozolinks

  • Level 1 Member
  • *
  • Posts: 4
Re: blinking front LED of a DNS-321?
« Reply #3 on: March 05, 2012, 03:56:25 PM »
still not working  :(
Logged

cable2

  • Level 3 Member
  • ***
  • Posts: 299
Re: blinking front LED of a DNS-321?
« Reply #4 on: March 08, 2012, 02:03:35 PM »
Hi,
The only thing I can think of is to try the "reset to factory defaults", assuming you cannot get to the interface, use a paperclip in the "reset" hole on the back of the unit.  With the unit power on, hold it in for 10-15 seconds and then release.  If you still get nothing but the blinking after a couple of minutes, I would think it is either the unit or something with the hard drive.  You could pull the hard drive out and test it out in a windows machine.  Here is the sticky for data recovery, http://forums.dlink.com/index.php?topic=41306.0 , if you are using Windows, in linux, you should be able to just check it easily.  If the drive is ok and your 321 keeps blinking, I would assume you had a bad unit.  If the reset works, you will have to re-enter your settings, but the data should be ok.  Good luck
Logged