Hello from Spain
( sorry for my bad english 
).- I have Firmware Version: 1.09..- Previusly, I had my DNS-323 with a Samgung 1TB, in left slot.
.- Yesterday I bought a HDD with AFT,
Toshiba 2TB DT01ACA200 thats really cames from Hitachi Division and model number (HDS723020BLE640).
.- I put inside (right slot) Toshiba 2TB HDD alone, DNS-323 detect it, and I could format at 100%, with no issues.
100% Correct Fromat with version 1.09 ? Yes, I guess..- Reboot, I can see my 2TB HDD, no problem, copy 1gb file to test speed --> 11Mb/s. All fine.
.- From the Web Interface (STATUS) I can see the hard disk.
Volume Name: Volume_1
Volume Type: Standard
Total Hard Drive Capacity: 1967954 MB
Used Space: 1538 MB
Unused Space: 1966416 MB
PHYSICAL DISK INFO :
Slot Vendor Model Serial Number Size
Right Hitachi HDS723020BLE640 MS77215W05M4WG 2000 G
.-
BUT, I have installed flunpug 0.7, and i did it "fdisk -lu" command:
sh-4.1# fdisk -lu
Disk /dev/sda: 2000.4 GB, 2000398934016 bytes
255 heads, 63 sectors/track, 243201 cylinders, total 3907029168 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x00000000
Device Boot Start End Blocks Id System
/dev/sda1 63 1060289 530113+ 82 Linux swap / Solaris
/dev/sda2 2088450 3907024064 1952467807+ 83 Linux
/dev/sda4 1060290 2088449 514080 83 Linux.- The hard disk, now works fine, by the moment... but the values from fdisk not are 4 multiples.Have/Must aling the partition ?
if YES, What is the correct way to do it ? (reformat with 1.10 version ?)
THANK YOU VERY MUCH FOR YOUR COLLABORATION...
Author
Topic: Happy with NEW "Toshiba 2TB DT01ACA200" but Worried about aling AFT....???? (Read 4947 times)