Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[rs_acc1]

Hi everyone!

I just got a new router and I am having some problems with it.
I tried searching through the forums and I couldnt find anything.

Basically, I have a LAMP server for a small landing page for myself.
It was all working fine until I got my new router.

Now, I can only access my sites on a LAN.
All the ports (3306, 80, 22) are opened and multiple port checkers online says so.

I followed some of the basic steps mentioned in this forum such as firewall settings such as:
"Port and Address Restriced"
disabled QoS
Enabled Multicast Stream
enabled DNS Relay
set DHCP range to avoid any IP conflicts
Ive even temporarily removed all firewalls completely to make sure that is not the problem.

I am so frustrated!

Haha if anyone can share some insight, it would be much appreciated!

[FurryNutz]

Link>Welcome!
What Hardware version is your router? Look at sticker under router.
Link>What Firmware version is currently loaded? Found on routers web page under status.
What region are you located?

What ISP Service do you have? Cable or DSL?
What ISP Modem make and model do you have?

[rs_acc1]

My router is Hardware Version: E3 and Firmware Version: 5.10.
I live in Ontario Canada.
Teksavvy is my ISP and I have cable internet.
My modem is Thomson DCM 476.

I think that is everything?

Also, I thought it was worth pointing out that my routers default gateway shows my WAN IP address.
And Ive tried both enabling and disabling SPI on the Advanced-->Firewall page.
Ive also tried both enabling and disabling UPnP since there are no game consoles and no one else in the house needs networking features.

[FurryNutz]

Set Firewall settings to Endpoint Independent for TCP and UDP under Advanced/Firewall.

Disable uPnP for testing Port Forwarding rules.

You might try using Virtual Server options instead of PFg.