Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[eirav67]

Hi,
on my dlink 5222L , hw rev. A2, firmware 1.10 (this is the last available version  on my country dlink site) i noticed that ntp synchronization only happens one time when I configure ntp from the web config interface. When the camera is rebooted the ntp synchronization does not work.

do you notice a similar behavior ?

[WolfKodi]

Update to latest firmware v1.11 from here: https://www.mydlink.com/support
You do not need to use the one from your country's dlink site as this firmware works globally.

[eirav67]

Hi Wolfkodi,
i read everywhere that it's absolutly not a good idea to install a generic firmware. (for example here: http://forums.dlink.com/index.php?topic=49256.0).
Why are you so sure this could be possible ? Did you do some tests ?

[WolfKodi]

Hi eirav67,
My local dlink site points to the singapore dlink site for latest firmware updates. I've also downloaded a copy of the latest firmware from from the official US dlink site and did a cmd comp command and found no differences between the two files.

[WolfKodi]

Also, that firmware region warning is only applicable to other dlink products such as routers where their firmware versions does have a region code appended behind the firmware number displayed on the top right corner of the web GUI page such as "WW".

[javajix]

Hi all,
i have the same problem with latest firmware 1.11.

I setup NTP correctly with dlink servers and date/time are correct,
but every time i reboot the camera the time never syncronize.

[Acumen]

Have you tried a different NTP server ?
For example: 0.pool.ntp.org

Or if DNS is not working, try to use the IP address.

[javajix]

Same problem using the ip instead of the name.
When i swtich off the unit and switch on, it has the wrong time date; i must go to "time and date settings" and change ntp server to have the right time/date.

I tried different servers and different ips but the problem persists.

[Robbiedoes]

I can confirm that this problem will be fixed with firmware 1.12  . After installing this version a few weeks ago, I didn't have any problems anymore and time is set correctly by NTP every time the camera boots (my camera is only activated when I'm not at home).