Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[cardon]

Hello,

I connect to the Internet through PPPOE. However, there's a problem. When I type in login and password through WizzardSetup after Factory Reset, I am able to connect but I don't see domains. When I switch Multicast streaming Enabled ip4 to "Enabled," the state of connection changes to "Busy."
Even if I remove the checkmark, I am not able to connect at all. The only thing that helps is doing Factory Reset and not change any settings afterwards.
Please help.

[FurryNutz]

Link>Welcome!

• What Hardware version is your router? Look at sticker under router.
• Link>What Firmware version is currently loaded? Found on the routers web page under status.
• What region are you located?

Internet Service Provider and Modem Configurations

• What ISP Service do you have? Cable or DSL?
• What ISP Modem service link speeds UP and Down do you have?
• For DSL/PPPoE connections on the router, ensure that "Always ON" option is enabled.

Router and Wired Configurations
Some things to try: - Log into the routers web page at 192.168.0.1. Use IE, Opera or FF to manage the router.

• Turn off ALL QoS or Disable Traffic Shaping (DIR only) GameFuel (DGL only and if ON.) options, Advanced/QoS or Gamefuel.
• Turn off Advanced DNS Services if you have this option under Setup/Internet/Manual or under Setup/PARENTAL CONTROL/Set to>None: Static IP or Obtain Automatically From ISP.
• Enable Use Unicasting (compatibility for some ISP DHCP Servers) under Setup/Internet/Manual.
• Turn on DNS Relay under Setup/Networking. Link>Finding Faster DNS Addresses using Name Bench
• Setup DHCP reserved IP addresses for all devices ON the router. Setup/Networking. This ensures each devices gets its own IP address when turned on and connected, eliminates IP address conflicts and helps in troubleshooting.
• Ensure devices are set to auto obtain an IP address.
• If IPv6 is an option on the router, select Local Connection Only or Disable IPv6 options under Setup/IPv6.
• Set Firewall settings to Endpoint Independent for TCP and UDP under Advanced/Firewall. Enable or Disable SPI to test.
• Enable uPnP and Multi-cast Streaming under Advanced/Networking. Disable uPnP for testing Port Forwarding rules. Enable IPv6 Multi-cast Streaming for routers that have a Media Server option. Disable IPv6 Multi-cast Streaming if IPv6 or Media Server is not being used.
• Turn off WISH, and WPS under Advanced.
• WAN Port Speed set to Auto or specific speed? Some newer ISP modems support 1000Mb so manually setting to Gb speeds can be supported by the router. Advanced/Advanced Networking/WAN Port Speed
• Set current Time Zone, Date and Time. Use an NTP Server feature. Tools/Time.

Ensure Local Domain has a name under Setup/Networking on the router and that your workgroup names on the devices are set for the same...

[cardon]

Version 1.05b07
Region : Ukraine
ISP Service: Cable

[FurryNutz]

• What ISP Modem Mfr. and model # do you have?

Just curious, most cable service providers here use DHCP and not PPPoE. Just confirming that your ISP needs PPPoE?

[cardon]

Yes need PPPoE. If I set DCHP I only get an inside local ip without Internet access. And if you use a VPN then I can not get local domains even the same VPN server, u have to connect on to the VPN.

[FurryNutz]

I know that some VPNs don't allow local domain access on the LAN side. I don't know what it would do if on the same VPN server side. You'll need to consult the VPN support dept for support on that.