Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[mikkimus]

Cable 50/5, dynamic ip adressing.
Cisco EPC3010

[FurryNutz]

Thank you.

Let us know if you phone contact them and if you get any info. I passed this onto D-Link and they should pass it along it your region. I probably won't hear anything back. I will post if I do.

Good luck and enjoy for now.

[mikkimus]

It's been a week or so of testing, and v1.02 and v1.03(unofficial download) works great.
However v1.02 has issues with upnp, so I went back to the unofficial v1.03 which can't be found on D-Link servers. upnp works in v1.03.
v1.04 is supposed to fix vulnerabilities in upnp apparently.

I'm curious if anyone is running this device on v1.04 without problems?
 

[mikkimus]

Any news from the front Furrynutz?

[FurryNutz]

I haven't heard anything and I suspect that I won't as this is a regional issue as this time and FW issue as you don't experience any issues with going back to v1.03.

Have you phone contacted your regional office about this yet?

One thing you can try, follow this and reload v1.04 and see if you still experience the issue:
Emergency Recovery Mode

[mikkimus]

Yeah, but I'm on the UNofficial v1.03 download, which works great, like the official v1.02 did.
But official v1.02 has problems with upnp and v1.03 has security problems.

[FurryNutz]

I know...it would be worth a test of the v1.04 using the recovery mode. You can always go back to v1.03 if this fails. 

[FurryNutz]

Let us know if this works or not. Might have another solution to try.

[mikkimus]

Will try Emergency Recovery Mode and report back.

[FurryNutz]

Let us know how it goes. 

[mikkimus]

ERM did not solve the problem
Same issues, the wizard hangs on v1.04 and config. utility dies.
I'm back on v1.03

[FurryNutz]

Sent you a PM...

[FurryNutz]

Ok so there seems to be an issue with v1.04 for sure.

I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this. We find that phone contact has better immediate results over using email. Let them know the prior versions you have tested don't exhibit this and then ask them if there is any newer official versions that will fix this. I believe that there maybe some FW that does. Have them check there TEMP site. 

Let us know how it goes.

[mikkimus]

Contacted my regional D-Link support on the issue and said that v1.04 is most likely buggy and directed them to my thread. They said there is v1.05 in the works but not officially released. But soon they said.

[FurryNutz]

Awesome, Thank you for sharing this information and hope they will get it posted soon for others that see this same issue.

Enjoy.