Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[davevt31]

Not all cable/dsl modems allow you to telnet into them.  You will have to contact your ISP for assistance.
I know my modem is 192168.100.1, so your numbers may be different too.

Is 192.168.1.1 your routers address?  You need to telent to your modem not the router.

[davevt31]

That link (to Russian dlink site)in the previous post is information about setting up WOL on a ASDL modem which is totally different than this router. 

[FurryNutz]

Try this:
http://forums.dlink.com/index.php?topic=37018.0

[churin]

Hi churin,

When you change the IP Default Address of the D-Link DIR-655 Router, it specifically tells you:
Reset to Factory Defaults and configure using the Default Address of the Router.

Reset to Factory Defaults and configure using the Default Address of the Router.

I have no problem accessing the router at 192.168.1.1. by any browser. Do you still think I should change it back to 192.168.0.1?

[thecreator]

Reset to Factory Defaults and configure using the Default Address of the Router.

I have no problem accessing the router at 192.168.1.1. by any browser. Do you still think I should change it back to 192.168.0.1?

Hi churin,

Why did you change it to 1.1 in the first place?

Also note: You can't telnet from within your Home Network to a place within your Home Network.

Telnet works from external IP Addresses, not internal.

Change it back. And then use LogMeIn Free. As long as a single Wired computer is on, you can turn on other Wired Computers only. Can't turn on Wireless.

[churin]

Hi churin,

Change it back. And then use LogMeIn Free. As long as a single Wired computer is on, you can turn on other Wired Computers only. Can't turn on Wireless.

I think the LogMeIn will work with any router IP.
I see it's an idea that I get a slow but very low power consumption PC and use as suggested but as a last resort.

[churin]

Try this:
http://forums.dlink.com/index.php?topic=37018.0

Thanks for your reply.
I reviewed the linked post and found that that is the way I had done except 1. and 6.  I do not need setting up DDNS because I have a way to remotely check the public IP for the target machine.  I do not think Windows Firewall is something which interferes turning on the machine.  I am using the GUI Magic Packet sender by Depicus as one in your list.

Please note that 1) WOL works if packet is sent out from within the same LAN and 2)WOL from the Internet works if the magic packet is sent out within about 30 seconds after it is turned off.

[daedao]

WOL from the Internet works if the magic packet is sent out within about 30 seconds after it is turned off.

churin and others,

If you're on A4 firmware 1.20, have a look at this hack, to solve the ARP cache flushing issue that causes WOL over the Internet to not work after a couple of minutes have passed since the PC was put to sleep mode.

http://forums.dlink.com/index.php?topic=16404.msg127219#msg127219

The thread is The DIR-655 WOL Knowledgebase Thread