• November 01, 2024, 01:25:08 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: SP2 install fails  (Read 4051 times)

gorilla

  • Level 1 Member
  • *
  • Posts: 1
SP2 install fails
« on: February 02, 2009, 07:54:49 PM »
I am in New Zealand and am trying to test the Voice Center system which is on loan from D-Link here. During the upgrade process I receive the following dialog box message:

Administrator - Microsoft Response Point

The base unit has restarted, but the version of the Response Point software that it is running [1.0 SP1 (Build 1.14.4217.0)] is not the version it was upgraded to [1.0 SP2 (Build 1.20.4926.0)]. This can happen if the software upgrade of the base unit failed. Administrator will continue to monitor the base unit and proceed with the upgrade if the software installation succeeds.

Is this a limation of the demo hardware, or have I done something wrong? I have tried a number of times and have rebooted the base unit.

cheers,
Paul.
Logged

Mlachake

  • Poweruser
  • Level 3 Member
  • ***
  • Posts: 203
Re: SP2 install fails
« Reply #1 on: February 03, 2009, 08:54:00 AM »
If you have SP1 already installed, you shouldn't have any problem upgrading to Sp2. Please contact D-Link New Zealand technical support personnel for assistance. Here is a link for the contacts:
http://www.dlink.co.nz/tech/.
Logged