Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[PacketTracer]

Hi,

I'm using DIR-825 Rev. B2 (according to the sticker at the bottom side of the device; the Web-GUI says it were Rev. B1) with the latest EU firmware V.2.09EUb09 (date 14.01.2013) -- details about this firmware and where to get it, see here: New EU firmware version 2.09EUb09.

I tested both 6to4 and IPv6 in IPv4 tunnel (copied your configuration data), but I couldn't reproduce your negative results concerning the status pages. There is one exception: It is not always possible to show the current LOGS pages, but this phenomenon is independent of IPv6 configuration and happens from time to time (in all firmware versions I have used so far: V.2.04EUb02, V.2.05EUb09 and 2.09EUb09). It disappears after the next sending of a full log via e-mail.

The only strange thing I saw from your config_with_ipv6.bin file is your local IPv4 address: 192.168.0.1/255.255.254.0 (this corresponds to the range 192.168.0.0 - 192.168.1.255). This might be okay in terms of CIDR, but I don't know what your DIR-825 box "thinks" about that.

PacketTracer

[FurryNutz]

Thanks for posting PacketTracer,

@Cornholio
Let us know if you decide to try the v2.09 FW. Please follow the FW update process. Hope it will fix this for you.

Let us know.

[Elandal]

B1 hardware here.
I haven't been able to acces IPv6 status page with FW v2.09EUb09 either. Used to work with FW v2.05EUB09. IPv6 in IPv4 tunnel as well.

[FurryNutz]

Was a factory reset performed both before And after updating FW and then set up the router from scratch?

[Kev D]

B1 hardware here.
I haven't been able to acces IPv6 status page with FW v2.09EUb09 either. Used to work with FW v2.05EUB09. IPv6 in IPv4 tunnel as well.

Dito here. I'm now using 2.08EU firmware & IPv6 works fine. When I upgrade to 2.09EUb09 all IPv6 routing on clients break (except when pinging directly from the router web interface). Tried with backup restore & tried from scratch, both same results. When I revert to 2.08EU & setup from scratch or load my backup all works fine again.

[FurryNutz]

Sounds like something broke in v2.09EU. I would phone contact DLink support. Ask for level 2 or higher support. Let us know if you find out anything.

Dito here. I'm now using 2.08EU firmware & IPv6 works fine. When I upgrade to 2.09EUb09 all IPv6 routing on clients break (except when pinging directly from the router web interface). Tried with backup restore & tried from scratch, both same results. When I revert to 2.08EU & setup from scratch or load my backup all works fine again.