• February 22, 2025, 02:54:48 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Cable Diagnostics  (Read 11057 times)

sigmajt

  • Level 1 Member
  • *
  • Posts: 3
Cable Diagnostics
« on: April 06, 2010, 10:30:09 AM »
I am finding the cable diagnostics feature interesting but have a few questions
One cable reads OK on pairs 1 and 2 but pairs 3 and 4 read short in cable.  Is this a bad condition?  Since I see no TX error or RX error on that port is it OK to ignore this?

The one that really has me confused is a cable that's OK on pair 1, impedance mismatch on 2 and 3 and OK on 4 what does impedance mismatch mean and what if anything should i do to fix it?
Also is cable distance being measured from the device to the terminating NIC or from the device to the wall patch panel?
Logged

Fatman

  • Poweruser
  • Level 9 Member
  • ****
  • Posts: 1675
Re: Cable Diagnostics
« Reply #1 on: April 06, 2010, 10:44:05 AM »
Ideally you don't want any shorts or impedance mismatches.

Impedance mismatch is a more complex cable fault, but for our purposes just consider it a cable fault.

That said I don't think I have ever seen anyone throw up a new cable run because 1 pair showed as bad without affecting functionality.
Logged
non progredi est regredi

sigmajt

  • Level 1 Member
  • *
  • Posts: 3
Re: Cable Diagnostics
« Reply #2 on: April 06, 2010, 11:23:54 AM »
good enough, thanks
Logged