Hi
It's been 3 days that I'm working on the following setup.
Note, same setup with Cisco Catalyst switchs works
.
Note :
www.pfsense.org is a router/fw
PFSENSE > SWITCH1 > SWITCH2
pfsense ip : 10.0.0.254/8
switch1 ip : 10.0.0.50/8
switch2 ip : 10.0.0.51/8
VLANS on PFSENSE + DHCP for each VLANS
VID 10 / VLAN10 / 10.0.10.0/24
VID 20 / VLAN20 / 10.0.20.0/24
VID 30 / VLAN30 / 10.0.30.0/24
VID 40 / VLAN40 / 10.0.40.0/24
VID 50 / VLAN50 / 10.0.50.0/24
VID 60 / VLAN60 / 10.0.60.0/24
VID 70 / VLAN70 / 10.0.70.0/24
VID 80 / VLAN80 / 10.0.80.0/24
VID 90 / VLAN90 / 10.0.90.0/24
VID 100 / VLAN100 / 10.0.100.0/24
VID 110 / VLAN110 / 10.0.110.0/24
VID 120 / VLAN120 / 10.0.120.0/24
VID 130 / VLAN130 / 10.0.130.0/24
PFSENSE to SWITCH1 is connected on port 50.
SWITCH1 to SWITCH2 are connected on ports 49.
What I want to do on switch1.
PORTS 1-10 : VID 1 / DEFAULT
PORTS 11-12 : VID 10 / VLAN10
PORTS 13-15 : NOT USED, DISABLED
PORTS 16-20 : VID 20 / VLAN20
PORTS 21-25 : VID 30 / VLAN30
PORTS 26-30 : VID 40 / VLAN40
PORTS 31-35 : VID 50 / VLAN50
PORTS 36-40 : VID 60 / VLAN60
PORTS 41-45 : VID 70 / VLAN70
PORTS 46-47 : VID 80 / VLAN80
PORT 48 : NOT USED, DISABLED
PORT 49 : TO SWITCH2
PORT 50 : TO PFSENSE
What I want to do on switch2.
PORTS 1-10 : VID 1 / DEFAULT
PORTS 11-20 : VID 90 / VLAN90
PORTS 21-25 : VID 100 / VLAN100
PORTS 26-30 : VID 110 / VLAN110
PORTS 31-35 : VID 120 / VLAN120
PORTS 36-40 : VID 130 / VLAN130
PORTS 41-48 : NOT USED, DISABLED
PORT 49 : TO SWITCH1 (receive other VLANS)
PORT 50 : NOT USED, DISABLED
I'm going crazy with thoses switchs
.
Thx for help !
