Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[storagedns]

Hello forum, newbie on this one but not on forums in general.

Here's the problem, had this unit since firmware 1.00 ( didn't do much with that )

Upgraded to 1.1 when it became available and the unit worked to it's known performance.

1.2 became available, upgraded and again it worked until like a month ago when all of a sudden I lost traffic speed - went down from like 10 MB/s to like 100 KB/s write or read doesn't matter.

I rebooted and since it says "System is booting ..... " and it just won't boot totally cause that message won't change. Any other reboots won't make the message go away or the unit to perform to it's performance.

Unit is normally hooked up to a Netgear GSM 7248 L2 managed switch and port had been tested with several other equipment OK, even tied to the PC performance is the same.

I can access the web page, all settings are in place, it won't reboot or shut down from the web page, it won't take any other firmware from the web page, after download it'll say file corrupt or unknown, downloaded public releases 1.03 and 1.04 from the site several times so file isn't "corrupted" it'll simply not take it. 

So question now is, did anybody experienced this and is it any way to get past it ?

[JavaLawyer]

Did you try reverting to the "factory default settings" in the web interface under Maintenance -> System?

[storagedns]

Thanks for reply, yes that had been tried, same result .....