Hi all,
I just thought I would post my testing and findings on this issue.
I have seen here and other places that many of us are plagued with this problem, some people seem to have it solved (maybe).
Up front, wanted to post a few very important points (important for me, anyway).
1. I have a very low-end Linksys router I bought at a yard sale for $5 that does NOT disconnect wireless clients every 10 minutes.
Regardless of any other equipment or changes (or lack of changes), this router works.
For me, this point completely eliminates:
- Intereference
- Software or drivers on any of my clients, xbox, iPhone, etc..
2. I have pushed and received an RMA from Dlink. They replaced my DIR-655 with another (assuming a refurbished), no change to the problem.
3. I believe I have tried most of the suggestions found on forums as well as suggested by dlink support (including NOT hiding ssid, changing default transmission rates / MTU, changing channels, using a utility to find unused channels, moving the router, resetting, turning off all xtra features like uPNP, QOS, etc.)
Why am I going through all this? Because I feel cheated out of my $90. I did some research before buying a router (reviews, "top ten", etc).
I had been using a Linksys WRT54G for a long time, but wanted some new features (mainly some advance firewall control, QOS, better speeds, and DHCP Res.
As I continue I am beginning to question this post, since I think I am pretty much at the point of giving up.
I know I have not included many specifics like firmware / hardware rev, WPA settings, etc. but I have burned out on this and will only state that I know what all these are, I have tried changing these (when reasonable) and it has not helped.
Anyhow, thanks for reading, I suppose this has at least been therapeutic for me, and if anyone out there has solved this problem (especially someone with diverse network clients, wired and wireless) I would greatly appreciate the suggestions.
Thanks all, and good luck,
Ribs