Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[nettyguy]

Hi Guys,

I did a speedtest in speedtest.net, often I am getting "Upload test error". After that I couldn't browse anything and I checked with various browsers and the result is same.

After reboot of router, internet is fine. And again did a speed test again the result is same. To dig further I did wireshark analysis on browsing www.bbc.co.uk. In that I couldn't see a GET HTTP on connecting to bbc server.

Can anybody tell me
1) What would be the reason for internet working after router reboot
2) Will speed test change any settings/functionalities of a router?3) Any dependencies related to firewall settings of laptop?

Any input would be appreciated.Thanks

[FurryNutz]

Link>Welcome!

What Hardware version is your router? Look at sticker under router.
Link>What Firmware version is currently loaded? Found on routers web page under status.
What region are you located?
Are you wired or wireless connected to the router?
Has a Factory Reset been performed?

What ISP Service do you have? Cable or DSL?
What ISP Modem Mfr. and model # do you have?
Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values
For DSL/PPPoE connections on the router, ensure that "Always ON" option is enabled.

Some things to try: - Log into the routers web page at 192.168.0.1. Use IE, Opera or FF to manage the router.
Turn off ALL QoS or Disable Traffic Shaping (DIR only) GameFuel (DGL only and if ON.) options. Advanced/QoS or Gamefuel.
Turn off Advanced DNS Services if you have this option under Setup/Internet/Manual or under Setup/PARENTAL CONTROL/Set to>None: Static IP or Obtain Automatically From ISP.
Enable Use Unicasting (compatibility for some ISP DHCP Servers) under Setup/Internet/Manual.
Turn on DNS Relay under Setup/Networking. Link>Finding Faster DNS Addresses using Name Bench
Setup DHCP reserved IP addresses for all devices ON the router. Setup/Networking. This ensures each devices gets its own IP address when turned on and connected, eliminates IP address conflicts and helps in troubleshooting.
Ensure devices are set to auto obtain an IP address.
If IPv6 is an option on the router, select Local Connection Only or Disable IPv6 options under Setup/IPv6.
Set Firewall settings to Endpoint Independent for TCP and UDP under Advanced/Firewall.
Enable uPnP and Multi-cast Streaming under Advanced/Networking. Disable uPnP for testing Port Forwarding rules. Enable IPv6 Multi-cast Streaming for routers that have a Media Server option. Disable IPv6 Multi-cast Streaming if IPv6 or Media Server is not being used.
Turn off WISH, and WPS under Advanced.
WAN Port Speed set to Auto or specific speed? Some newer ISP modems support 1000Mb so manually setting to Gb speeds can be supported by the router. Advanced/Advanced Networking/WAN Port Speed
Set current Time Zone, Date and Time. Use an NTP Server feature. Tools/Time.

[davevt31]

I have seen issues with the using Begin Test link.  I just pick a server and run the test from it.