Link>
Welcome!What Hardware version is your router? Look at sticker under router.
Link>What
Firmware version is currently loaded? Found on routers web page under status.
What region are you located?
Has a Factory Reset been performed both before and after the FW update then setup from scratch?
What ISP Service do you have? Cable or DSL?
What ISP Modem Mfr. and model # do you have?
Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>
Checking MTU ValuesFor DSL/PPPoE connections on the router, ensure that "Always ON" option is enabled.
Some things to try: - Log into the routers web page at 192.168.0.1.
Use IE, Opera or FF to manage the router.Turn off ALL
QoS or Disable Traffic Shaping (DIR only) GameFuel (DGL only and if ON.) options. Advanced/QoS or Gamefuel.
Turn off Advanced DNS Services if you have this option under Setup/Internet/Manual or under Setup/PARENTAL CONTROL/Set to>None: Static IP or Obtain Automatically From ISP.
Enable Use Unicasting (compatibility for some ISP DHCP Servers) under Setup/Internet/Manual.
Turn on DNS Relay under Setup/Networking. Link>
Finding Faster DNS Addresses using Name BenchSetup DHCP reserved IP addresses for all devices ON the router. Setup/Networking. This ensures each devices gets its own IP address when turned on and connected, eliminates IP address conflicts and helps in troubleshooting.
Ensure devices are set to auto obtain an IP address.
If IPv6 is an option on the router, select Local Connection Only or Disable IPv6 options under Setup/IPv6.
Set Firewall settings to Endpoint Independent for TCP and UDP under Advanced/Firewall.
Enable uPnP and Multi-cast Streaming under Advanced/Networking. Disable uPnP for testing Port Forwarding rules. Enable IPv6 Multi-cast Streaming for routers that have a
Media Server option. Disable IPv6 Multi-cast Streaming if IPv6 or Media Server is not being used.
Turn off WISH, and WPS under Advanced.
WAN Port Speed set to Auto or specific speed? Some newer ISP modems support 1000Mb so manually setting to Gb speeds can be supported by the router. Advanced/Advanced Networking/WAN Port Speed
Set current Time Zone, Date and Time. Use an
NTP Server feature. Tools/Time.
Links>
Wireless Installation Considerations and
Managing Signal Congestion Ensure the default (dlink) SSID name is changed. Can be anything and not something thats already in use by any neighboring WiFi routers. Under Setup/Wireless/Manual.
What wireless modes are you using?
Try single mode G or N or mixed G and N?
Channel Width set for Auto 20/40Mhz or try 20Mhz only.
Try setting a manual channel to a open or unused channel. 1, 6 or 11. 11 for single mode N if the channel is clear.
What security mode are you using? Preferred security is WPA-Personal. WPA2/AES Only. Some WiFi adapters don't support AES, so you might want to try TPIK only or Auto.Any other WiFi routers in the area? Link> Use
InSSIDer to find out. How many?
Try turning off
Short GI, WLAN Partition,and Extra Wireless Protection if you have it. Under Advanced/Advanced Wireless.
Enable
WMM Enable Under Advanced/Advanced Wireless.