Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[gfsilva]

I just bought a set of 4 DCS-932L cameras and a DNR-322L (Firmware 1.5).
All devices have been configured correctly and can be accessed by port 80 inside my network.
The problem is that DNR-322L becomes "offline" in mydlink (and only in mydlink) a few minutes after a restart (it is connected to router by cable).
My guess is that the ports are being blocked by the router's firewall. Can someone please tell me what ports must be open to operate correctly in mydlink.
This is really important, because I need the equipment to work remotely.

Thanks.

[RYAT3]

I just bought a set of 4 DCS-932L cameras and a DNR-322L (Firmware 1.5).
All devices have been configured correctly and can be accessed by port 80 inside my network.
The problem is that DNR-322L becomes "offline" in mydlink (and only in mydlink) a few minutes after a restart (it is connected to router by cable).
My guess is that the ports are being blocked by the router's firewall. Can someone please tell me what ports must be open to operate correctly in mydlink.
This is really important, because I need the equipment to work remotely.

Thanks.

What ports did you set up each camera to use outside?

And is your router port forwarding to them correctly?

[gfsilva]

I just tested the system with one camera.
I have set the camera on port 800 and have enabled both "UPnP" and "UPnP port forwarding" (which is supported by the router), so the traffic from the camera is being correctly forwarded.

I think the problem is from forwarding the traffic from the DNR-322L. What ports should be opened (to remotely access it from mydlink portal)?

Thanks for your help.

[LapinGrey]

i've got the same problem.. with 5 dcs-932l wifi connected, the nvr goes offline after few days of working. and i need to solve urgently this issue!!! in order to make it operative again, i need to unplug the power cord and reboot the device. help me please!!

[Dalsvzla]

Hi guys

Im having this exact problem but with the new DNR-202L

Did you find out the solution?


Thanks