Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[MrWhite]

Pretty simple bug,  I have 2 of these and both of them exhibit this problem.  After a day or so of continuously being on (sometimes after a few hours), the plug cuts power.  The green LED on the front still indicates as though it is switched on (the "switched on" LED, not the WiFi connected LED).  I haven't set any schedules and the power limit is "off".  Both running the 1.02b5 firmware (latest).

Super annoying.

[JavaLawyer]

I will forward this issue to D-Link for review and post back if I learn anything.    

[MrWhite]

So this issue seems to still happen to me on the 1.10 firmware.  It's gotten much better though and seems to happen after a few months of leaving the plug in "on" mode, but for example this morning I woke up and the temperature of my aquarium was 30degreesC because the plug had turned itself off.

[FurryNutz]

Just curious, was is the power requirements of the aquarium devices? I presume a water pump and heater?

[MrWhite]

Chillers so about 800W total power.

[FurryNutz]

Ok, checking. Do the Chiller AMP draw more than 15amps by chance?

These are rated at Up to 1800W / 15Amps

[fockers]

I have a same problem with my device too. It is cut the power without any reason.
I podded two tickets to the support about this issue without any answer. It is not very professional from DLink side. 
The firmware is 2.03(latest). The load is less than 13A. No schedule, no thermal protection, consumption matter is off and I don’t have any rule. DSP-W215 seems to be a very good device but D-Link have to work a lot on it: some simple web interface, some simple log, even I can’t check the real time clock in the device is it correct.

[FurryNutz]

We find that phone contact has better immediate results over using email.
Let us know how it goes please.

I have a same problem with my device too. It is cut the power without any reason.
I podded two tickets to the support about this issue without any answer. It is not very professional from DLink side. 
The firmware is 2.03(latest). The load is less than 13A. No schedule, no thermal protection, consumption matter is off and I don’t have any rule. DSP-W215 seems to be a very good device but D-Link have to work a lot on it: some simple web interface, some simple log, even I can’t check the real time clock in the device is it correct.