Link>
Welcome!- What Hardware version is your router? Look at sticker under the router case.
- Link>What Firmware version is currently loaded? Found on the routers web page under status.
- What region are you located?
- Are you wired or wireless connected to the router?
Internet Service Provider and Modem Configurations- What ISP Service do you have? Cable or DSL?
- What ISP Modem Mfr. and model # do you have?
- Is ISP Modem/Service using Dynamic or Static WAN IP addressing?
- What ISP Modem service link speeds UP and Down do you have? Link> Speed Testing Sites
- By-pass the main host router and check internet connection by connecting a wired LAN PC directly to the ISP modem to verify connection access and ISP speeds.
- Check cable between Modem and Router, swap out to be sure. Link> Cat6 is recommended.
- Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values
Wireless ConfigurationsLinks>
Wireless Installation Considerations and
Managing Signal Congestion and
Good Neighbour Policy - Ensure the default (dlink) SSID name is changed. Ensure that different SSID names are used between each WiFi 2.4/5Ghz radios. Can be anything and not something that's already in use by any neighbouring WiFi routers. Under Setup/Wireless/Manual.
- What wireless modes are you using?
Try single mode G or N or mixed G and N?[/li]
[li]Channel Width set for Auto 20/40Mhz or try 20Mhz only.[/li]
[li]Try setting a manual
Channel to a open or unused channel. 1, 6 or 11. 11 for single mode N if the channel is clear. 13 for EU regions.[/li]
[li]What security mode are you using? Preferred security is WPA-Personal. WPA2/AES Only. Some WiFi adapters don't support
AES, so you might want to try
TPIK only or Auto TPIK and AES. [/li]
[li]What wireless devices do you have connected?[/li]
[li]Ensure any devices with WiFi adapter drivers are updated.[/li]
[li]Any 2.4Ghz or 5Ghz cordless house phones or WiFi APs near by that maybe causing interferences?[/li]
[li]Any other WiFi routers in the area that maybe causing interferences? Link> Use
InSSIDer to find out.
How many? Use v3, its free.[/li]
[li]If you have any of these options, Try turning OFF or ON
Short GI, WLAN Partition, Extra Wireless Protection and HT 20/40 Co-existence if you have it. Also testing with HT20/40Mhz Co-existence enabled will impact results as well. I prefer to use this option OFF. Recommended settings are default. Under Advanced/Advanced Wireless. [/li][/list]
Router PlacementForum User - "Well I feel really dumb. After moving the router away from other electronic devices my speeds are back to normal. Just a heads up for anyone experiencing slow speeds, you might want to move it away from other electronics and see if that helps."
3-6' feet minimum safe distance between devices.
Placement on main level floor and central in the building and WELL ventilated is preferred. Not in basements or closets as building materials, or near by electronics devices could interfere or hinder good signal propagation.
http://www.smallnetbuilder.com/wireless/wireless-basics/31083-smallnetbuilders-wireless-faq-the-essentials
Author
Topic: DIR 615 reboot endlessly (Read 5299 times)