Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[DoubleChi]

I get 90mbps solid normally but after a day or 2 it will drop to 30 until I either reboot the router or login and release/renew through the DLINK UI.

Is there a fix for this? Its extremely frustrating...

[FurryNutz]

Link>Welcome!

• Link>What Firmware version is currently loaded? Found on the routers web page under status.
• What region are you located?
• Are you wired or wireless connected to the router?
• Has a Factory Reset been performed?
• Was a Factory Reset performed before and after any firmware updates then set up from scratch?

  Link> >FW Update Process

• Was the router working before any firmware updates?

Internet Service Provider and Modem Configurations

• What ISP Service do you have? Cable or DSL?
• What ISP Modem Mfr. and model # do you have?
• By-pass the main host router and check internet connection by connecting a wired LAN PC directly to the ISP modem to verify connection access and ISP speeds.
• Check cable between Modem and Router, swap out to be sure. Link> Cat6 is recommended.
• Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values

[DoubleChi]

Link>What Firmware version is currently loaded? Found on the routers web page under status.
              1.08
What region are you located?
              Chicago
Are you wired or wireless connected to the router?
              Wired
Has a Factory Reset been performed?
              Yes
Was a Factory Reset performed before and after any firmware updates then set up from scratch?
              Defaults to 1.08 (current)
Was the router working before any firmware updates?
              Does not apply

Internet Service Provider and Modem Configurations
What ISP Service do you have? Cable or DSL?
              Comcast, cable modem
What ISP Modem Mfr. and model # do you have?
              Aftermarket Motorola Surfboard6141
By-pass the main host router and check internet connection by connecting a wired LAN PC directly to the ISP modem to verify connection access and ISP speeds.
              works fine
Check cable between Modem and Router, swap out to be sure. Link> Cat6 is recommended.
              swapped cable same result after a day or so
Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values
              1500 HERE IS A MTU TEST RESULTS via LetMeCheckIt.com

[FurryNutz]

Happen on all wired PCs?

[DoubleChi]

Happen on all wired PCs?

Yes, wireless too

[FurryNutz]

Care to try the beta? Mines doing well with it.

Either do a factory reset and manually reload v1.08, factory reset then set up from scratch and test again. Do the same thing for v1.09 if you decide to try it.