Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[LukasMH]

Hello,

I am trying to setup my router DIR-605L HW:B1 Firmware:2.08 to enable Back to My Mac functionality on my Mac, but without success.
Error message is:
"Back to My Mac may be slow because NAT Port Mapping (NAT-PMP) or Universal Plug and Play (UPnP) is turned off on your router."

but problem is that in router settings UPnP is enabled.

Is it possible to enable this functionality?
Is there someone with similar problem or with solution? 

Thanks.

[FurryNutz]

Link>Welcome!

• What region are you located?
• Are you wired or wireless connected to the router?

Internet Service Provider and Modem Configurations

• What ISP Service do you have? Cable or DSL?
• What ISP Modem Mfr. and model # do you have?

What Apple device do you have and what OS version is currently loaded?

[LukasMH]

What region are you located?
- mid Europe / Slovakia

Are you wired or wireless connected to the router?
- wireless

What ISP Service do you have? Cable or DSL?
- Cable

What ISP Modem Mfr. and model # do you have?
- Cisco Modem EPC3010 (Modem NO: 185078150)

What Apple device do you have and what OS version is currently loaded?
- Macbook Pro Mid 2014 (Model A1398, EMC 2881)

[FurryNutz]

Might check with Apple and this Back to My Mac service to see if there is any special ports that's needing used on the router.
Try putting your Macs IP address in the routers DMZ and test.