Hi. I need some help here!
I have a 932L cam for some time, and sometimes it loses the configuration and I have to reset to default and configure again (including register to mydlink). I remember that always had some issues but eventually I succeeded.
Today, I spent more than 4 hours and couldn't register, don't know what else to do!
I tried some times with the current firmware and then I find out that there is a new version. I already installed it but still can't make it works...
The situation is: I have a router connected to internet and a notebook wired connected to the router. I wired connected the cam to the router, reset to default config, open the web UI and configured the password and network (so it's on the same ip range of notebook). After that, tried to run setup wizard (just downloaded again from dlink download page). The wizard finds the cam, shows the correct ip, shows that its not registered, everything is ok. So I select it, put the password and click next. The wizard check the pass, go to select a conection type. I already tried all 3 options (wired/wireless/WPS) and the result is the same: it says canīt connect to the internet... When I open the web UI, check the config, it's ok (tried DHCP and static IP) but nothing I did so far seems to correct that.
Now I find the forum and see that I can register using the mydlink app. Ok, tried that. Also didn't work... I did everything as explained on the topic about it (
http://forums.dlink.com/index.php?topic=61856.0), my cam appears on the 'nearby cam', I started the adding process, type password, select yes to add to the current acount, but after a few moments a message pops up showing that it failed to associate the device to this acount...
Anyone can help me???
Thanks!
Author
Topic: Can't register cam to mydlink (Read 10131 times)