Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Geert75]

Hey,

When i turn my Sharecenter on, only the power LED blinks and nothing else works.
I tried to reset it by pressing the reset button (min 8 sec like said on other topics in this forum) on the bottom off the device but nothing happens.
Can anyone help me?

[FurryNutz]

Link>Welcome!

• What Hardware version is your DNS? Look at the sticker behind or under the device.
• Link>What Firmware version is currently loaded? Found on the DNSs web page under status.
• What region are you located?

What Mfr and model is the main host router?

Try removing the drives, remember the order or placement of each drive. Then turn ON the DNS and see if you can access the UI at all.

Might look into a power supply issue. Have someone check the power supply to make sure the voltage and amps are to spec on the tip...

[Geert75]

HW Ver : A3
Firmware don't know because i can no acces the D Link. (The FW version on the sticker is 1.01
I already tried to start it up without the harddrives. The same result, power LED blinks and thats all.

[FurryNutz]

Id try to get another power supply adapter that has some voltage and amps that matches the current one as see if it continues to exhibit this issue...

[Geert75]

I attached an other power source the same problem stays.

I think it's an network issue, how strange it sound.
When i power up the DNS 320 before i boot my PC the DNS Powers up and work great.
When i boot up my PC first the DNS does not respons, just a blinking power LED.

[FurryNutz]

How do you have the PC and DNS connected? Via a router? What Mfr and model is this router?

[Geert75]

Indeed, both are connected via a router.
My Router is a Linksys Smart Wifi EA7500.
I my Setting of my router i don't see anything that could be wrong.

[FurryNutz]

What is the default IP address range of the Linksys router?