Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[GreenBay42]

Firmware: v1.03B04   08/08/2019 NA Region Only
Revision Info
Problems Resolved:   
1. Fixed Speedtest issue in some region
2. Fixed IPTV issue in some specific region/environment

Enhancements:
1. Improved user experience for Wi-Fi Mesh
2. Support DFS channel but DFS disable as default for IN country code
3. Support EU VLAN
4. AU/EU country code’s Wi-Fi Mesh default value is changed from disable to enable (new default value will be effect after factory default for the Wi-Fi Mesh ON by default change.)
5. IPv6 default value is changed from link local to auto detection. (new default value will be effect after factory default)
6. Improved stability
7. Improved VPN to create new account
8. improved DFS behavior when mesh is paired

Known Issues:
None

NOTE: If your router is working with out any issues, it's recommended to keep the current version of FW that is loaded unless your are effected by one of the fixes.

IF IT WORKS, DON'T FIX IT!!! 

Get it here: NA Region
DIR-2660-US

Please follow the> FW Update Process to ensure a good FW upgrade is performed.

Let us know how it works for you...

[FurryNutz]

Ok, mine was upgraded manually, factory reset and setup from scratch. QoS speed test was to spec. 200/10.
DCS-960L camera would not auto connect using same SSID and PW from last wifi system. I had to power cycle it. Eventually got connected.
Enabled Smart Connect and MESH and 160Mhz.
Have a DAP-1820 connected and appears as a extender. 

One item I saw was that I was not able to cancel or exit from the setup wizard. I was attempting to setup router manually since I already had a router online and wanted the 2660 setup prior before putting it online in place of the current router. I connected the LAN to the WAN port and was able to step thru the internet connection, then the wizard went to the wifi SSID input window. I disconnected the WAN port here and was able to continue the wizard then manually setup the rest of the router for my needs.

Will let this run.