Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[DaanBogers]

So I just installed D viewcam 5.2.0, and when I select a camera or try to move a camera the software crashes and restarts.
I reinstalled the software, didn't work. I also updated another PC that was running 4.x.x just fine to 5.2.0 and it has the same issue; When I try to select a camera the software just stops immediately.

This must be a real bug. Any tips to this?

Running Windows 10 Pro 64 bit, software is running with admin right.

[FurryNutz]

Can you try a different Windows 10 PC to see if problem follow?

Be sure all back ground running programs are exited.
Be sure no security programs are running as well to test.

[DaanBogers]

I've tested this with another PC that actually records the camera's. It has the same issue, crashes when trying to move camera images.
That other PC only runs D-Viewcam. Nothing else.

So I tested this on 2 systems. One is for real time monitoring, the other one is for recording. Both running 5.2.0.
Can anyone confirm the same issue?

[FurryNutz]

I'll load up this on one of my Windows 10 PCs and see what happens.

[FurryNutz]

FYI, I loaded v5.2.0 on a Windows 10 PC x64 PC yesterday. Clean install. DVC had not been installed at all prior.

After loading it up and launching the Main Console, I went in and added a DCS-933L, 936L and a 960L cameras to the console. The 936L and 960L are not officially supported by DVC so I used the DCS-942L model string to gain video access which works.

I saved the settings and went to the main console display. My 933L was the single video. I selected the 4 camera view and then all 3 cameras were seen. I selected each camera one at a time and was able to view each one separately. Then go back to the 4 camera display matrix on the main screen. These cameras don't support movement so I wasn't able to try that.

Saw no hangs or crashes.