Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Hovercraft]

I just set up a 1202 system yesterday but am still having some issues streaming to my Chromecasts. House is ~2500 sq FT, just a basement and ground floor. FW is 1.08, have two units with the B unit being hardwired via powerline.

Should I be using bridge mode or router mode? In bridge mode should my SSID match that of my router? Setup is working in that I have WiFi signal in whole house but streaming to my Chromecasts has been choppy and painful. Never had issues before except in dead zone of the house.

Any setup tips or tricks to get this working properly would be great. Thanks in advance

[FurryNutz]

Link>Welcome!

• What region are you located?
• Has a Factory Reset been performed?
• Was a Factory Reset performed before and after any firmware updates then set up from scratch?

  Link> >FW Update Process


Internet Service Provider and Modem Configurations

• What ISP Service do you have? Cable or DSL?
• What ISP Modem Mfr. and model # do you have?

AP (Bridge) mode is only used if you have another router in operation upstream or in front of the A Point router.

[Hovercraft]

Canada, firmware is 1.08 updated. I have fibreop internet, 300 Mbit.

I have it set up in bridge mode now and I reconnected the Chromecast again after switching to bridge mode. Seems to be a bit better now but I haven't had a chance to do a big streaming test yet. Will report back.

[FurryNutz]

What ISP Modem Mfr. and model # do you have?

[FurryNutz]

Any updates on this?

Canada, firmware is 1.08 updated. I have fibreop internet, 300 Mbit.

I have it set up in bridge mode now and I reconnected the Chromecast again after switching to bridge mode. Seems to be a bit better now but I haven't had a chance to do a big streaming test yet. Will report back.