Hello,
I've got DGS-1100-08 Rev B1 running software ver. 1.00.B037 (provided by support team to try and fix this issue).
I have ETH1/ETH2 set up for link aggregation channel #1 and ETH5/ETH6 for channel #2. The DGS switch is getting RX traffic on both ports on each aggregation group as there are several MACs / IPs on both groups / both ends. However the switch is only sending traffic over ETH1 / ETH5, no traffic is sent on ETH2 / ETH6 unless the other port is down, so this is actually working as primary/ backup and not load balancing at all on the DGS switch.
I have a case raised with DLINK support on this. Has anyone faced this issue and found a solution for it?.
Thanks.
Port TxOK TxErr RxOK RxErr
eth1 397675 0 250634 0
eth2 0 0 521648 0 <------
eth3 0 0 0 0
eth4 97820 0 99393 0
eth5 4980739 0 181644 0
eth6 0 0 7010560 0 <------
eth7 87 0 23839 0
eth8 6728433 0 4115992 0
