• April 19, 2025, 06:12:23 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Having to unplug DIR-655 because wired connection stops working  (Read 15976 times)

howie411

  • Level 1 Member
  • *
  • Posts: 8
Having to unplug DIR-655 because wired connection stops working
« on: September 02, 2009, 08:28:08 AM »
Ever since I installed firmware 1.31 and now 1.32 my wired connection stops working occasionally.  The only way to really fix it is to unplug the router and let it reset.  I have 6 wireless devices connected and none of them seem to have an issue.  I've tried just unplugging the wired PC but that doesn't seem to work.  Any ideas?
Logged

Sammydad1

  • Level 5 Member
  • *****
  • Posts: 722
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #1 on: September 02, 2009, 11:35:12 AM »
Hi,

Have you tried a different port on the back of the router ?  It is not unheard of for a single port to go "bad"....

SD1
Logged
DIR-655 A2, FW: 1.35NA

Toilet-Duck

  • Level 2 Member
  • **
  • Posts: 41
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #2 on: September 02, 2009, 04:38:49 PM »
I have the EXACT same problem, the wireless seems to work fine and can comunicate with other wireless devices but not wired devices. Since my Modem is connected via cable I have to reboot the router every week or two VERY annoying!  >:(
Logged

cmyers

  • Level 1 Member
  • *
  • Posts: 1
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #3 on: September 08, 2009, 08:06:41 AM »
Check your logs.  I have found this problem and it is related to Securespot.

My log continually shows the following:
Establishing connection w/ filter server: 165.193.79.44:443  (*could be anything near that IP address*)
It says this about every 5 seconds and then reports:
Temporarily disabling http(s) filter server communication for 120 seconds.
And the cycle starts all over

It seems like it never connects to Securespot.  I am having horrible performance problems.  It fails to connect to sites more often than not.

It all goes back to normal if I deselect Securespot from my router.

It also goes away if I unplug the router for a while.  Not just a quick reboot.  I shut it off all night last night and it seems to work this morning.  Not logging the above lines.
Logged

howie411

  • Level 1 Member
  • *
  • Posts: 8
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #4 on: September 08, 2009, 07:44:33 PM »
My securespot is already disabled.

My log says this a lot:

Failed configuration authentication attempt by IP address 192.168.0.194


(.194) is my desktop.
Logged

bigeyes0x0

  • Level 3 Member
  • ***
  • Posts: 163
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #5 on: September 08, 2009, 09:36:32 PM »
Did you enable network filter or access control in your DIR-655? Please check these settings, if you can't access your router, then reset it is the only cure.
Logged

mrberry

  • Level 1 Member
  • *
  • Posts: 4
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #6 on: September 24, 2009, 02:17:14 PM »
i am having the same issues too. i have to unplug the router after a few days. all networked devices stop working, even wireless. got 3 computers, nintendo wii, xbox360, dlink media player, laptop, and a voip phone. after a few days they all fail to be able to talk to each other over the lan or get online.
Logged

mazman

  • Level 1 Member
  • *
  • Posts: 18
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #7 on: September 25, 2009, 06:37:25 AM »
I'm having the same issues with my router and have had so since at least version 1.21. Every 3 days or so, the network connections slow to a crawl. Unplugging and/or rebooting the router fixes the problem.
Logged

anonposter

  • Level 2 Member
  • **
  • Posts: 58
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #8 on: September 25, 2009, 12:26:37 PM »
FYI... seems that most are disabling DNS relay to solve this issue.  Might want to try it out on your end.
Logged

mazman

  • Level 1 Member
  • *
  • Posts: 18
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #9 on: October 10, 2009, 10:44:52 PM »
Quote from: anonposter on September 25, 2009, 12:26:37 PM
FYI... seems that most are disabling DNS relay to solve this issue.  Might want to try it out on your end.
It's been 2 weeks since I disabled DNS relay as you advised and sure enough the router lockups/slowdowns etc. have ended!

Thanks for your help.
Logged

howie411

  • Level 1 Member
  • *
  • Posts: 8
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #10 on: October 16, 2009, 02:24:10 PM »
I tried that and my desktop wouldn't even get an IP address anymore.  There was just a checkbox I clicked.
Logged

KevTech

  • Guest
Re: Having to unplug DIR-655 because wired connection stops working
« Reply #11 on: October 16, 2009, 05:59:37 PM »
Quote from: howie411 on October 16, 2009, 02:24:10 PM
I tried that and my desktop wouldn't even get an IP address anymore.  There was just a checkbox I clicked.

Try rebooting your PC after the change.
Logged